Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) 5. Leak on hydraulic circuit. - Repair or replace defective part(s). SUSPENSION BOTTOMS HARD. 6. Faulty suspension position sensor. - Test sensor and replace as required. 1. Spring(s) out of specification or broken. - Replace the defective spring(s). 2. Shock absorber is damaged. - Check shock absorber resistance. Replace shock absorber. 7. Actuator is damaged. - Replace the actuator. 3. Bump stops damaged or worn. - Replace both bump stops. 8. Hydraulic pump cannot build enough pressure. - Replace hydraulic pump. SUSPENSION MOVES ERRATICALLY. SUSPENSION QUIT WORKING BUT MAY OPERATES MOMENTARILY AFTER RESTARTING THE ENGINE. 1.
Defective shock absorber. - Replace the shock absorber. 1. Hydraulic pump current draw is too high. - Check hydraulic pump. 2. Broken spring(s). - Replace spring(s). 2. Internal problem inside iS module. - Replace iS module. SUSPENSION NOISE (DURING A TURN). 1. Front or rear suspension arm shaft supports po- sition. - Supports must be leaned against both ends of shaft. Reposition shaft in its supports. 2. Worn arm shaft bushings. - Check front and rear arm shaft bushings condition and replace as required. 3. Snap rings on both sides of the rear lower arm shaft are not properly positioned. - Reposition shaft in its supports. SUSPENSION NOISE (FRONT OF SEAT). 1.
Screws retaining holders are loosened. - Tighten shock absorber and actuator holder screws to recommended torque. 2. Shock absorber screws are loosened. - Tighten shock absorber screws to recommended torque. 3. Link under actuator holder loosened or not in- stalled. - Install link properly. - Tighten bolts to recommended torque. SUSPENSION IS LOWER THAN THE DOCK MODE POSITION. 1. Spring (s) out of specification or broken. - Replace the defective spring(s). 2. Bump stops damaged or worn. - Replace both bump stops. 442 smr2009-041