Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) PROCEDURES SHOCK ABSORBER Shock Absorber Removal 1. Remove the moving deck. Refer to BODY sub- section. 2. Remove tapes securing central bellows to mounting plate. 3. Move down central bellows to reach shock holder screws. 4. Remove and discard the four screws securing the shock holder. NOTE: Using lateral supports, raise front arm to reach front screws. smr2009-041-005_a 1. Shock absorber lower bolt (discard) 2. Shock holder 7. Detach the top of shock absorber from mount- ing plate. Discard bolt. smr2009-041-006_a 1. Shock absorber upper bolt (discard) 2. Mounting plate Shock Absorber Inspection NOTE:
Because of gas pressure, strong resis- tance is felt when compressing shock. To inspect shock operation, or if suspecting an in- ternal leak between oil chamber and gas chamber, check shock as follows: 1. Grab the shock absorber body firmly and press the other end against the floor. 1.1 Verify the compression stroke when the rod is fully extended. 1.2 Make sure that shock absorber rod can be completely inserted in the shock body. smr2009-041-003_a 1. Front retaining screws smr2009-041-004_a 1. Rear retaining screws 5. Remove shock absorber with mounting plate and shock holder. NOTE: Take care not to let the spring protector fall into the hull. 6.
Remove and discard the bolt securing shock ab- sorber to shock holder. smr2009-041-040_a smr2009-041 445