Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) 2. The shock should extend unassisted. Rod must come out at a steady speed. If any problem is detected, replace the shock ab- sorber. Shock Absorber Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. Secure the shock absorber using NEW bolts. Tighten bolts to 75 N•m (55 lbf•ft). Install NEW shock holder screws and tighten them to 25 N•m (18 lbf•ft). smr2009-041-090_a 1. Zone where presence of rust is normal Check the curve line of long spring. SPRINGS Spring Removal 1. Remove SHOCK ABSORBER, see procedure in this subsection. 2.

Remove the spring protector, the long spring, the spacer, the short spring and the spring holder. smr2009-041-041_a A. 7 mm (9/32 in) maximum Replace spring if out of specification. Spring Installation The installation is the reverse of the removal pro- cedure. SUSPENSION POSITION SENSOR smr2009-041-007_a 1. Spring protector 2. Long spring 3. Spacer 4. Short spring 5. Spring holder The suspension position sensor is a potentiome- ter that sends a signal to the iS module which is proportional to the front suspension arm angle. NOTE: Prior to testing the sensor, ensure that components of suspension are good and installed correctly.

If a problem occurs with the suspension, several fault codes pertaining to the suspension position sensor will be generated. Refer to MONITOR- ING SYSTEM AND FAULT CODES subsection for more information. Spring Inspection Inspect both springs and replace if one of the fol- lowing damage is detected: Crack in the paint Rust Other visible damages. Replace spring if one of these problems is de- tected. NOTE: If rust is present ONLY on the first 1/4 of coil, the spring should not be replaced. 446 smr2009-041 LONG SPRING SHAPE Maximum 7 mm (9/32 in)