Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) Suspension Position Sensor Input Voltage Test At Sensor Connector 295000136 5. Using the FLUKE 115 MULTIMETER (P/N 529 035 868) , check voltage as per the following table. Using the 6-pin Magneto Harness Tool 1. Connect B.U.D.S. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE subsection. 2. Using B.U.D.S., raise suspension in fully up po- sition. 529035868 smr2009-041-053_b ACTIVATION AND IS TABS 1. iS UP 2. iS down NOTE: If the seat is moving up and the number does not increase in B.U.D.S. but it is between 10 and 100%, check the suspension position sensor fork. 3. Unplug the 6-pins connector from the iS mod- ule.

The module is located in front of the bat- tery in the same compartment. 6. Remove the 6-pin magneto harness tool. Suspension Position Sensor Resistance Test At iS Module Connector 1. Using the FLUKE 115 MULTIMETER (P/N 529 035 868) , check resistance values on iS connector as per the following table. smr2009-041-009_a 1. Suspension position sensor connector on iS module 4. Connect the MAGNETO HARNESS 6 PINS (P/N 295 000 136) to iS module for voltage checks.

smr2009-041 447 SUSPENSION POSITION SENSOR CONNECTOR VOLTAGE Pin 1 Pin 2 5 Vdc SUSPENSION POSITION (% in B.U.D.S.) MAGNETO HARNESS (wire lead color) VOLTAGE (Vdc) All positions BK BK/YL 4.99 100% WH BK/YL 3.23 100% BK WH 1.75 88% WH BK/YL 3.09 88% BK WH 1.89 75% WH BK/YL 2.99 75% BK WH 1.98 53% WH BK/YL 2.81 53% BK WH 2.16 35% WH BK/YL 2.68 35% BK WH 2.30