Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) 529035868 smr2009-041-011_a 1. Sensor connector 2. Hydraulic pump reservoir 4. Remove screws securing the suspension posi- tion sensor. smr2009-041-012_a 1. Retaining screws 5. Remove bolts securing the sensor and its cover to the sensor support and the sensor lever. Suspension Position Sensor Replacement The suspension position sensor is located on sus- pension base, under the hydraulic pump reservoir. 1. Remove the deck extension. Refer to BODY subsection. 2. Remove the air intake tube. Refer to AIR IN- TAKE SYSTEM subsection. 3. Unplug the suspension position sensor connec- tor. smr2009-041-013_a 1. Retaining bolt 2. Sensor 3.
Support 4. Lever 5. Cover 6. O-rings NOTE: If water is present into sensor always re- place sensor even if it seems in good condition. 6. Check condition of O-rings on sensor and sen- sor lever. 7. Reinstall all parts. 448 smr2009-041 SUSPENSION POSITION (% in B.U.D.S.) iS MODULE (6-pin connector) RESISTANCE All positions 4 6 1803 - 2203 100% 5 6 1957 - 2391 100% 4 5 1361 - 1663 88% 5 6 1904 - 2327 88% 4 5 1410 - 1724 75% 5 6 1871 - 2287 75% 4 5 1448 - 1770 53% 5 6 1799 - 2199 53% 4 5 1516 - 1852 35% 5 6 1752 - 2142 35% 4 5 1565 - 1913