Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) NOTE: When reassembling parts, index sensor lever shaft with sensor inner slot. The sensor lever must be positioned to 180° with the sensor electrical connector. smr2009-041-055_a Repeat the test using a test light. smr2009-041-014_a 1. Lever 2. Lever shaft 3. Sensor 8. Reinstall and connect the sensor in vehicle. If the input voltage test is good, check the iS mod- ule input voltage (battery power). If there is no voltage, check 5 A fuse (FB1, item 11) for voltage. If the fuse is good and there is voltage present at the fuse, check the continuity of the iS module switched power wire.

iS MODULE iS Module Overview The iS module communicates via CAN protocol with the multifunction gauge. The iS module receives information from the mul- tifunction gauge and a comparison is made with the input from the suspension position sensor. If the suspension is not in the proper position, the iS module will then send an output signal to the hy- draulic pump to either raise or lower the suspen- sion to pre-programmed positions. Continuity Test of iS Module Switched Power Wire iS Module Input Voltage Test (Switched Power) Press the START/STOP button to activate the electrical system. Install the D.E.S.S. key. Using the FLUKE 115 MULTIMETER (P/N 529 035 868) , perform the following test.

smr2009-041-056_a CONNECTOR PIN 1 TO FUSE BOX PIN B3 If the reading is not to specification, check the wires, connectors and terminals from the iS mod- ule 6-pin connector to fuse box (FB1). If the continuity test is good, check the iS module input voltage test (battery power). smr2009-041 449 TEST LIGHT POSITION RESULT Pin 1 of iS Module 6-pin connector Negative battery post Bright light iS MODULE 6-PIN CONNECTOR FUSE BOX PIN (FB1) RESISTANCE Pin 1 B3 .5 MULTIMETER LEAD POSITION VOLTAGE (VDC) Pin 1 of iS Module 6-pin connector Negative battery post Battery voltage