Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) iS Module Input Voltage Test (Battery Power) Using the FLUKE 115 MULTIMETER (P/N 529 035 868) , perform the following test. Continuity Test of iS Module Battery Power Wire smr2009-041-057_c PIN 2 TO FUSE BOX PIN A4 smr2009-041-057_a PIN 1 TO BATTERY POSITIVE POST iS Module Output Voltage Test At the 2-pin connector, connect multimeter leads. Activate the iS either UP and DOWN with B.U.D.S. or with iS button on steering. There will be either a positive 12 Vdc or a negative 12 Vdc reading. Activate the opposite UP or DOWN and the read- ing should reverse polarity.

If the test passes, perform the test again using a 12 V test light to ensure the circuit can supply enough current to operate the hydraulic pump. The light should be bright in both the UP or DOWN positions. smr2009-041-057_b PIN 2 TO BATTERY NEGATIVE POST Repeat the test using a test light. If there is nothing from pin 1 to positive battery post, check engine ground. If there is nothing from pin 2 to negative battery post, check voltage at the 30 A fuse (item 16) in fuse box 2 (FB2). If the fuse is good and there is voltage present, check the continuity of the iS module battery power wire. iS Module Removal 1. Open boarding platform and remove the star- board storage bin. 2.

Disconnect the suspension position sensor connector from the iS module. 450 smr2009-041 iS MODULE 3-PIN CONNECTOR FUSE BOX (FB1) RESISTANCE Pin 2 A4 .5 iS MODULE 3-PIN CONNECTOR BATTERY VOLTAGE (VDC) Pin 1 Positive post Battery voltage Pin 2 Negative post Battery voltage FUSE BOX (FB2) RESISTANCE A3 A4 .5 FUSE BOX (FB2) STARTER SOLENOID RESISTANCE A3 Battery terminal connection .5 iS MODULE 3-PIN CONNECTOR BATTERY RESULT Pin 1 Positive post Bright light Pin 2 Negative post Bright light