Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) smr2009-041-034_a 1. Suspension position sensor connector smr2009-041-037_a 1. iS module input voltage connector 3. Detach the retaining latch. NOTE: The locking tab of input voltage connector is located underneath. 6. Remove the iS module from vehicle. iS Module Installation The installation is the reverse of the removal pro- cedure. iS BUTTON iS Button Overview The iS button contain a series of 4 diodes for the UP and DOWN arrow switches. The center wire to the switches (pin C), is com- mon for iS button and VTS button. The other two wires (pins A and B), act as signal wires for each set of switches to the gauge.
They actually each form one branch of an electronic circuit within the gauge. Each diode (in circuit) drops a nominal 0.6 Vdc when conducting electricity. If the circuit current passes through all four diodes (if the iS switch is open), a drop of 2.4 Vdc would be measured across the 4 the diodes (pin B to pin C). This 2.4 Vdc at pin B tells the gauge the iS switch is open. If the iS UP switch is pressed, 2 diodes are by- passed. The remaining two diodes in the circuit drop 1.2 Vdc (at pin B). If the iS DOWN switch is pressed, 1 diode is by- passed. The remaining three diodes in the circuit drop 1.8 Vdc (at pin B).
The gauge senses these voltages through pin 14 of its connector, and interprets them as signals that tell it which switch is activated. If the command generated by the closure of a switch concerns the iS module, a circuit within the gauge will translate it to CAN protocol and smr2009-041-035_a 1. Retaining latch 4. Disconnect the hydraulic motor connector. smr2009-041-036_a 1. Hydraulic motor connector 5. Disconnect the iS module input voltage connec- tor. smr2009-041 451