Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) transmit it through the CAN bus. The module will react to the command, carry out the function, and transmit the result back through the CAN bus. The gauge will use the signals from the switches and the transmitted information from the other modules, convert them to an indication, and cancel the command signal it sent out once the function has been carried out. Command signals from the iS button are translate and sent to the iS module. NOTE: The above stated voltages vary slightly de- pending on the actual voltage applied to the circuit and the current flow through the diodes.
When using a Fluke 115 multimeter for testing in diode test mode, the voltage and current applied by the multimeter are lower than in circuit. The quality of probe contact, the actual probes and leads, and the precision of the meter calibration will all affect the results, which will most likely be slightly lower than nominal values stated. smr2009-042-002_a 1. Gauge connector 2. Slide out gauge connector tab to unlock 3. Using the FLUKE 115 MULTIMETER (P/N 529 035 868) set to the diode test function, test the iS Up or DOWN switches as per following tables. NOTE: In diode test mode, the multimeter will test the voltage drop through the diodes.
iS Button Operation Test If iS UP or DOWN switches do not allow the se- lection, test the switches as follows: Check the iS button operation using B.U.D.S. software. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE subsection to con- nect B.U.D.S. Check if there is any occurred or active fault code(s). If not, proceed with the following test. Depress the iS UP switch on steering and check if the suspension UP light turn on. Repeat with the iS DOWN switch. Suspension Down light should turn on. vmr2006-020-005 smr2009-041-051_a MONITORING AND CLUSTER TABS 1. Suspension UP light If one switch does not function, replace iS button.
If both switches stay off, do the following to verify the circuit. 1. Remove the gauge support cover. 2. Disconnect the gauge connector. 452 smr2009-041