Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) 5. Remove and discard socket screws securing rear brackets to arm shaft ends. smr2009-041-071_a 1. Bad installation 2. Good installation smr2009-041-069_a 1. Socket screw 2. LH rear bracket 3. Lower the rear suspension arm on fixed deck. 4. Tighten NEW socket screws to 10 N•m (89 lbf• in ). 5. Refer to REAR ARM for reinstallation. 6. Press one rear bracket against the suspension arm bushing and remove the circlip. Repeat for the other side. smr2009-041-070_a 1. Circlip Installation of Rear Suspension Arm Lower Shaft 1. When reassembly the rear bracket on shaft end, press bracket on bushing to install the circlip. 2.

When both brackets are installed on shaft, pull brackets outside to position circlips against brackets. smr2009-041 465