Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) smr2009-041-078_a 1. Support pin 2. Holder hole smr2009-041-079_a 1. Bar clamp 2. New socket screws 4. Tighten the LH support screws to 25 N•m (18 lbf•ft). 5. Apply a force on the RH support to move it on the left side. NOTE: A bar clamp can be used to compress both supports together. Removal of Rear Suspension Arm Lower Shaft 1. Open the boarding platform. 2. Remove bolts securing both rear suspension arm covers. NOTICE Make sure arm shaft is fully inserted, it must lean against the arm shaft support. smr2009-041-067_a 1. Arm shaft against its support smr2009-041-072_a 1. Rear suspension arm cover 6.

Install NEW support screws and tighten them to 25 N•m (18 lbf•ft). 7. Secure both supports to shaft using NEW socket screws. Tighten them to 12 N•m (106 lbf• in ). 3. Mark position of rear suspension arm brack- ets for proper reinstallation . 4. Remove and discard screws securing rear sus- pension arm to fixed deck. smr2009-041-074_a 1. Rear suspension arm screws 464 smr2009-041