Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) 5.3 Reposition rear suspension arm brackets on fixed deck until positioning of moving deck is satisfactory. 6. Secure the rear suspension arm to the fixed deck. 6.1 Install NEW screws to secure rear suspen- sion arm brackets. 6.2 Remove and replace screws installed dur- ing alignment. 6.3 Tighten screws to 25 N•m (18 lbf•ft). 6. Install NEW support screws and tighten them to 25 N•m (18 lbf•ft). 7. Secure both supports to shaft using NEW socket screws. Tighten them to 12 N•m (106 lbf• in ). Removal of Rear Suspension Arm Upper Shaft 1. Unclip and remove both lateral rear panels.
SUSPENSION ARM SHAFTS Removal of Front Suspension Arm Shaft 1. Remove the FRONT SUSPENSION ARM, see procedure in this subsection. 2. Remove and discard socket screws securing supports to shaft. 3. Separate arm shaft supports from arm shaft. Installation of Front Suspension Arm Shaft 1. To reinstall the shaft, insert it in the suspension arm. 2. Install a support on each end of shaft. 3. Secure the LH arm shaft support to suspension base using NEW support screws. NOTE: Make sure to insert the support pin into suspension base hole. 4. Tighten the LH support screws to 25 N•m (18 lbf•ft). 5. Apply a force on the RH support to move it on the left side. smr2009-041-073_a 1.
RH lateral rear panel 2. Remove arm shaft support screws. NOTICE Make sure arm shaft is fully inserted, it must lean against the arm shaft support. smr2009-041-077_a 1. Arm shaft support screws 3. Remove and discard socket screws securing supports to arm shaft. 4. Separate arm shaft support from arm shaft. Installation of Rear Suspension Arm Upper Shaft 1. To reinstall the shaft, insert it in the rear arm. 2. Install a support on each end of shaft. 3. Secure the LH support to rear arm holder using NEW support screws. NOTE: Make sure to insert the support pin into holder hole. smr2009-041-067_a 1. Arm shaft against its support smr2009-041 463