Section 07 BODY AND HULL Subsection 02 (BODY) 2. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of shock absorber body. 3. Tighten manually the attachment on gas shock. 4. Install the bellows and secure it using a locking tie. 5. Install the gas shock on cover. NOTE: The corrugated section of bellows must pointed downward. 6. Align boarding platform hinge openings with flat sides of fixed hinges. 7. Push in the boarding platform to assemble hinges. 8. Position the bottom of the gas shock on cavity opening. SPLASH DEFLECTOR Splash Deflector Removal sdd2009-001-052_a NOTICE To avoid breaking the attachment, do not force to insert it in cavity. 1.
To remove the splash deflector, drill out the 4 rivets securing the splash deflector to the fixed deck. 2. Pull the deflector from the fixed deck. NOTICE A molded location pin at each end of the deflector are each inserted into the fixed deck. Be careful not to break them when re- moving the deflector. Splash Deflector Installation 1. Position the splash deflector over the forward end of the fixed deck and press the guide pins into the holes provided in the deck. 2. Install four new rivets to secure the deflector to the deck. smr2009-042-038_a 1. Lower attachment on cavity opening NOTE: Make sure upper attachment is properly inserted in its slots. DECK EXTENSION smr2009-042-039_a 1.
Upper attachment 9. Close boarding platform to lock the bottom of the gas shock. 10. Lock boarding platform. smr2009-042-009_a 1. Deck extension Deck Extension Removal 1. Open seat. 2. Remove vent box. 468 smr2009-042