Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 02 (AIR INTAKE SYSTEM) GENERAL Rear Ventilation Box Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. Before installing the ventilation box, check the condition of its seal. If the seal is damaged, replace the ventilation box as an assembly. During assembly/installation, use torque values and service products as in the exploded views. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.:

locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be replaced with new ones. FRONT VENTILATION BOX Front Ventilation Box Removal 1. Open the front storage cover and remove the storage basket. 2. Remove screws securing the ventilation box to fixed deck. Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards. SYSTEM DESCRIPTION This vehicle is equipped with two ventilation boxes. The rear ventilation box is located over the engine and the front underneath steering column. These ventilation boxes allow a good bilge venti- lation and supply engine with fresh air. smr2009-017-003_a 1. Front ventilation box 2.

Retaining screws PROCEDURES 3. Remove the ventilation box. REAR VENTILATION BOX Rear Ventilation Box Removal 1. Open seat. 2. Release all retaining latches. Front Ventilation Box Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. Before installing the ventilation box, check the condition of its seal. If the seal is damaged, replace the ventilation box. Tighten ventilation box screws to 1.2 N•m (11 lbf• in ). AIR INTAKE DUCT Air Intake Duct Removal Remove engine. Refer to ENGINE REMOVAL AND INSTALLATION subsection. Remove the suspension base. Refer to iS SUS- PENSION subsection. Remove air intake duck from vehicle.

smr2009-017-010_a 1. Ventilation box 2. Retaining latches 3. Remove the ventilation box. smr2009-017 27