Section 02 ENGINE Subsection 02 (AIR INTAKE SYSTEM) Air Intake Duct Installation Install suspension base. Refer to iS SUSPENSION for complete procedure. Install engine. Refer to ENGINE REMOVAL AND INSTALLATION. After deck extension installation, tighten screws retaining the air intake duct to deck extension to 1.2 N•m (11 lbf• in ). Tighten clamp to 1.7 N•m (15 lbf• in ). AIR INTAKE SILENCER BAFFLE Air Intake Silencer Baffle Removal Remove AIR INTAKE SILENCER COVER, see pro- cedure in this subsection. Pull the baffle out of the air intake silencer. smr2009-017-005_a 1. Air intake silencer baffle smr2009-042-020_a 1.
Air inlet retaining screws AIR INTAKE SILENCER COVER Air Intake Silencer Baffle Installation Insert the end of the baffle into supercharger air inlet hose. Using hose ears to retain hose, push the baffle into supercharger air inlet hose. Air Intake Silencer Cover Removal Remove the deck extension. Refer to BODY sub- section for procedure. Release retaining latches. Loosen clamp securing blow-by hose to cover. smr2009-017-006_a 1. Baffle 2. Air intake hose Install air intake silencer cover and all other re- moved parts. AIR INTAKE TUBE smr2009-017-004_a 1. Retaining latches 2.
Loosen this clamp Air Intake Tube Removal Remove the AIR INTAKE SILENCER COVER and the AIR INTAKE SILENCER BAFFLE, see proce- dure in this subsection. Release the three rubber latches securing the air intake tube. Remove the cover. Air Intake Silencer Cover Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. Check the condition of the seal cover. Replace seal as required. 28 smr2009-017