Section 07 BODY AND HULL Subsection 02 (BODY) smr2009-042-051_a 1. Trace a line here smr2009-042-053_a 1. Protective skin 4. Insert bumper over body lip. 4.1 Insert lower section first. 4.2 Insert upper section last. 3. Pull the top of bumper to unclip it from body. NOTE: A heat gun can be used to soften side bumper. smr2009-042-052_a smr2009-042-052_b 1. Make sure bumper is positioned correctly Bumper Installation NOTE: A heat gun can be used to soften side bumper. Front and Rear Bumper The installation is the reverse of the removal pro- cedure. Tighten bumper screws to 5 N•m (44 lbf• in ). SPEED-TIE UNIT Front Speed-Tie Unit Removal 1. Open the glove box. 2.
Remove the plastic push-in clip securing the LH upper trim. Side Bumpers 1. Remove all remaining residues of the mounting tape. 2. Clean bumper area using isopropyl alcohol. 3. Remove the protective skin on mounting tape. ssi2009-003-002_a 1. Remove this plastic push-in clip 3. Move upper trim rearward and remove it. 484 smr2009-042