Section 07 BODY AND HULL Subsection 02 (BODY) ssi2009-003-030 15. Lock the end of rope as shown. ssi2009-003-033_a 18. Unlock the end of the rope and pull it out by the housing opening. NOTE: Be careful not to release the rope and the spring. Otherwise you will need to remove drum and repeat the cranking operation. 19. Install locking mechanism and rope. 19.1 Pull out rope end. 19.2 Insert end of rope through locking mech- anism. ssi2009-003-031 16. Install rewind unit into housing. 16.1 Install the rewind unit with the retaining screw downward. The end of rope must be placed in front of the housing opening. 16.2 Insert spring in shaft notch. ssi2009-003-034_a 1.
Locking mechanism 19.3 Pass rope end through the rope button and tie a knot on the rope end, see pic- ture. ssi2009-003-032_a 1. Spring in notch NOTE: Ensure spring is properly inserted in notch. 17. Using a screwdriver, crank rewind spring ex- actly 7 turns (clockwise). ssi2009-003-035_a 1. Rope A. 18 mm ± 6 mm (23/32 in ± 15/64 in) 19.4 Pull knot in the button and install the button cap. Make sure cap is properly snapped. 20. Install Speed-Tie cover. Tighten screws to 0.9 N•m ± 0.1 N•m (8 lbf• in ± 1 lbf• in ). 492 smr2009-042