Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 02 (BODY) 21. Check Speed-Tie operation. 22. Reinstall the Speed-Tie unit on vehicle. Remove back protective film from decal and align decal with marks. When well aligned squeegee decal beginning at center and working outward us- ing firm, short, overlapping strokes. Remove front protective film once decal has ad- hered to hull. DECALS Decal Removal Using a heat gun warm up one end of decal for a few seconds until decal can roll off when rubbing with your finger. NOTE: When heating near light surfaces, duct tape should be applied to protect the surface. Otherwise the light color could become a yellow- ish color.

Pull decal slowly and when necessary apply more heat to ease removal on the area that has to be peeled off. If decal tears while pulling off, it has to be heated for a few seconds longer. If decal tends to stretch while pulling off, stop heating and wait a few sec- onds to let it cool, then peel it off. Installation on Plastic Surface (Storage Cover) Clean surface with isopropyl alcohol and dry thor- oughly. Using a pencil and the decal as a template, mark the area where decal will be located. NOTICE Do not use soapy water to locate de- cal on plastic parts. Remove back protective film from decal and care- fully align decal with marks.

When well aligned squeegee decal beginning at center and working outward using firm, short, overlapping strokes. Remove front protective film once decal has ad- hered. Decal Installation (With a Protective Film on Back Side) These decals usually contain written information (e.g.: warning) and are used on gelcoat or metal. Using isopropyl alcohol, clean the surface and dry thoroughly. Using a pencil and the decal as a template, mark the area where decal will be located. Remove half of the decal back protective film and align decal with marks. Start sticking it from cen- ter and remove the other half of the film to stick it completely.

Carefully squeegee decal beginning at center and working outward using, firm, short, overlapping strokes. GELCOAT The fixed deck of this Sea-Doo is constructed of chopped fiberglass, saturated with resin. It is sprayed on the layer of gelcoat along with pieces of fiberglass mat, cloth and woven roving which are added at required areas. NOTE: For the hull, a different material is used. Gelcoat Repair Information NOTE: Fiberglass repair kit is available through automotive or marine suppliers. Gelcoat repair kits are available directly from Gelcote Interna- tional Ltd. Contact Information: Gelcote International Ltd.

174 Colonnade Road Suite 29 Ottawa ON Canada K2E 7J5 Decal Installation (With a Protective Film on Both Sides) These decals usually contain graphics and are used on gelcoat or plastic. Installation on Gelcoat Using isopropyl alcohol, clean the surface and dry thoroughly. Using a pencil and the decal as a template mark the area where decal will be located. For better adhesion a dry application is recom- mended, however, to ease decal installation a mild solution of soapy water can be sprayed over surface where decal will be installed. Phone: 613 225-2177 Toll Free: 877 435-2683 Email: info@gelcote.com smr2009-042 493