Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 02 (BODY) pieces evenly. Try to work quickly, you may only have 15 or 20 minutes. You may clean the brush with acetone. Wait until the repair has hardened before moving on to the interior repair. If the size of the opening is too large for the pieces to maintain the proper shape, you will have to use a backing support. It is a shaped piece of cardboard that fits flush to the interior surface and has a plastic layer on the repair side. It is held in place by tape or a support. Inside: Wipe down the area with acetone on a cloth. Apply the same procedure as for outside repair when laminating the alternating pieces of fiberglass material.

If a backing support was used, remove it before starting the repair. After the area has hardened, remove sharp edges of material from surface. If required paint the sur- face. Sanding Outside: This surface will have to be prepared for application of gelcoat. The size of the area will determine the gelcoating procedure to be used. Refer to the MINOR GELCOAT FRACTURES RE- PAIR. Buffing and Waxing Refer to the BUFFING AND WAXING in MINOR GELCOAT FRACTURES REPAIR. 496 smr2009-042