Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 03 (HULL) GENERAL Verify condition and operation of hinges and latch- ing mechanisms. Replace any damaged compo- nents. During assembly/installation, use torque values and service products as specified in the exploded views. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. smr2009-043-013_a 1. Inlet grate screws 2. Inlet grate NOTICE When applying threadlocker prod- ucts (anaerobic products), pay attention to prevent the product from coming into contact with ABS plastic parts (painted parts).

Plastic parts may develop cracks or other damages, and finished or painted surfaces may become damaged. NOTICE An impact screwdriver should be used to loosen screws. Inlet Grate Installation When installing inlet grate, install NEW screws with Scotch Grip. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be replaced with new ones. Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards. PROCEDURES INLET GRATE smr2009-043-013_b 1. M8 x 40 screw 2. M8 x 20 screws Inlet Grate Removal 1.

Remove inlet grate retaining screws using an impact tool and remove inlet grate. Discard the retaining screws. Follow this sequence referring to the illustration: 1. Hand tighten inlet grate screws., then torque screws to 35 N•m (26 lbf•ft) as per sequence in following illustration. smr2009-043-015_a INLET GRATE TORQUE SEQUENCE 500 smr2009-042