Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 03 (HULL) RIDE PLATE Ride Plate Removal NOTE: The jet pump support and ride plate must be removed as an assembly. The pump support is fastened to the ride plate and the forward pump support mounting screws cannot be accessed when the ride plate is installed. NOTICE If the ride plate is replaced, or removed and installed, the engine/drive- shaft/pump alignment must be checked. Refer to ENGINE REMOVAL AND INSTALLATION. smr2009-043-014_a 1. Hose fittings 1. Remove iBR gate and VTS trim ring, refer to iBR AND VTS subsection. 2. Remove jet pump and nozzle, refer to JET PUMP subsection. 3. Drain cooling system, refer to COOLING SYS- TEM subsection. 4.

Remove the battery from the watercraft, refer to CHARGING SYSTEM subsection. 5. Move the electrical accessories support and electrical harness above and to the right of the resonator box for improved access to the ride plate coolant hoses and fittings. 6. Reach in between the exhaust system res- onator and hull to loosen the gear clamps and disconnect both coolant hoses from the ride plate. NOTICE Removing the hose fittings from the ride plate prior to removing the ride plate pre- vents the possibility of damaging or breaking the fittings.

If fittings cannot be removed be- fore ride plate removal, carefully remove the ride plate with the fittings still installed, while paying particular attention to the hose fittings at the forward end of the ride plate. 9. Remove INLET GRATE, see procedure in this subsection. 10. Using an impact tool, remove and discard ride plate retaining screws. smr2008-036-008_a TYPICAL 1. Ride plate screws 11. Install a low height hydraulic bottle jack and 2 steel plates between ride plate and hull as per following illustration. smr2009-043-016_a 1. Exhaust system resonator 2. Gear clamps 3. Coolant hoses 7. Remove excess sealant from around the coolant hose fittings. 8.

Unscrew both hose fittings from the ride plate. smr2009-042 501