Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 03 (HULL) Ride Plate Installation 1. Install the jet pump support on the ride plate, see procedure in this section. NOTE: The jet pump support must be installed on the ride plate before installation of the ride plate on the watercraft. 2. Reinstall hose fittings on ride plate and torque to 7 N•m (62 lbf• in ). 3. Apply LOCTITE 5900 (P/N 293 800 066) sealant on ride plate and jet pump support circumference as seen in the following illustration. smr2009-043-036_a TYPICAL 1. Hydraulic bottle jack 2. Steel plates 12.

Heat edge of ride plate and the inside diam- eter of the pump support with a heat gun to soften the sealer before prying the ride plate and pump support off the watercraft. smr2009-043-018 LOCTITE 5900 SEALANT APPLICATION 4. Remove all excess sealant from ride plate mounting holes. Pay particular attention to the RH forward mounting hole. 5. Position ride plate on hull and engage NEW M8 screws with Scotch grip 5 turns by hand. 6. Position inlet grate and engage NEW retaining screws 5 turns by hand. Refer to INLET GRATE in this subsection. 7. Push ride plate completely forward and torque ride plate screws to 35 N•m (26 lbf•ft) as per following torque sequence.

smr2009-043-017_a APPLY HEAT HERE 13. Using a sharp knife, carefully cut the sealant around the ride plate edges. 14. Pump the hydraulic jack slowly to pry the ride plate from the hull. NOTE: If the ride plate needs to be taken apart, the jet pump support must be removed from the ride plate to access the screws at the forward end of ride plate. : Ride Plate Cleaning 1. Carefully scrape off all excess sealant from ride plate and hull. 2. Clean hull surface with BRP HEAVY DUTY CLEANER (P/N 293 110 001) to eliminate grease, dust and sealant residue. Clean fitting threads. smr2009-043-015_b TYPICAL 8. Torque inlet grate screws. See INLET GRATE INSTALLATION in this subsection.

502 smr2009-042   9