Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 03 (HULL) der the splash deflector indicates the exact loca- tion of the piece to cut out. Carry out the following steps. 1. Remove splash deflector, refer to BODY sub- section. 2. Using a drill bit 6 mm (1/4 in) in size MINIMUM , drill a hole at each of the five corners of the piece to cut out of the fixed deck as per follow- ing illustration. smr2009-043-027_a CUT HERE AT AN INWARD ANGLE 4. Unscrew and discard both elastic stop nuts holding the bow eyelet in place. smr2009-043-027_b DRILL HOLES HERE NOTICE Failure to drill holes as instructed may lead to cracks in the fixed deck. 3.

Using a small thin cutting wheel (such as used on a Dremel® rotary tool), make a precise clean cut along the scribed line in the fixed deck. NOTE: The cut should be made at an angle point- ing in towards the center of the piece to be cut. This will prevent the piece from falling through the hole on installation and increase the contact area for the repair. smr2007-034-109_a TYPICAL 1. Elastic stop nuts 5. Pull bow eyelet to remove it from watercraft. 6. Clean any residue of silicone sealant on hull. Bow Eyelet Installation 1. The installation is the reverse of the removal procedure. However, pay attention to the fol- lowing. 2.

Inside hull, apply LOCTITE 5150 (SILICONE SEALANT) (P/N 293 800 086) around eyelet mounting holes. 3. Install small washers and nylon washers on bow eyelet and insert it through hull holes. 4. Inside hull, install rubber washers, large wash- ers and NEW elastic stop nuts. 5. Torque nuts to 14.5 N•m (128 lbf• in ). NOTICE Do not cut hole opening larger than etched line to prevent weakening of fixed deck and to ensure proper sealing of splash deflec- tor on installation. 508 smr2009-042