Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 03 (HULL) 4. Clean any residue of silicone sealant from the hull. Stern Eyelet Installation 1. Install small washers and nylon washers to stern eyelet and insert it through the hull. 2. Inside hull, apply LOCTITE 5150 (SILICONE SEALANT) (P/N 293 800 086) all around holes. 3. Install eyelet and other parts using NEW elastic stop nuts as per following illustration. smr2007-034-110_a 1. Bow eyelet 2. Small washer 3. Nylon washer 4. Loctite 5150 (silicone sealant) here 5. Rubber washer 6. Large washer 7. Elastic stop nut 6. Repair the hole cut in the fixed deck using the piece cut out during removal.

Refer to the BODY subsection for fiberglass repair proce- dure. NOTE: The previous step is not mandatory if splash deflector is properly sealed as detailed in following step. 7. Apply a bead of LOCTITE 5150 (SILICONE SEALANT) (P/N 293 800 086) to the inside of the splash deflector as in following illustration. smr2007-034-112_a 1. Stern eyelet 2. Small washer 3. Nylon washer 4. Loctite 5150 (silicone sealant) here 5. Rubber washers 6. Large washers 7. Elastic stop nuts 4. Torque retaining nuts to 14.5 N•m (128 lbf• in ). HULL INSERTS Metal inserts (brass) of various types and sizes are screwed into the hull at various locations.

A threaded hole in the insert is used for fastening various parts and equipment onto the hull (engine mounts, battery mounts, ride plate, sponsons, etc). Some inserts pass completely through the hull, while others do not (blind hole inserts). Some are designed to accept an M6 screw while others an M8 screw. smr2009-043-028_a APPLY SILICONE HERE 8. Reinstall the splash deflector on the fixed deck. STERN EYELETS Stern Eyelet Removal 1. Open boarding platform and remove the appli- cable storage tray. 2. Inside hull, unscrew and discard elastic stop nuts securing the stern eyelet to hull. 3. Pull stern eyelet to remove it from watercraft. smr2009-042 509