Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 03 (HULL) smr2009-043-025_a 1. Passe thru insert smr2009-043-026_b BLIND HOLE INSERT 1. Excess glue on head 3. Use a six pan socket of appropriate size and a ratchet wrench to unscrew the insert from the hull. NOTE: An impact tool may be used to facilitate removal of the insert. Insert Installation 1. Clean the insert hole in the hull to remove any dirt or loose glue using clean, dry, oil free fil- tered air. NOTICE Do not use a metal tool to clean or remove the glue inside the hull insert hole to prevent damaging the threads in the hull ma- terial. The glue that is properly bonded to the hull does not need to be removed. smr2009-043-026_a 1.

Blind hole insert All type inserts may be replaced if the inner screw threads are damaged beyond use. NOTE: Inserts should only be replaced as a last resort. First try passing a tap, cleaning the hole, and using a NEW screw with Scotch Grip thread- locker. If fastener can be tightened to the speci- fied torque, do not change insert. If torque cannot be applied, drill and tap insert one size larger be- fore trying to change an insert. 2. If the insert passes completely through the hull, screw a stud of appropriate size into the insert (M6 or M8) to prevent any glue from seeping into the fastener threads in the insert. Apply DEVCON HP 250 Q glue to the outer threads of the insert. NOTE:

Apply a sufficient amount of glue thru the full length of the insert threads to ensure excess glue will come out of the hole as the insert is screwed into the hull. 3. If the insert screws into a blind hole, apply DE- VCON HP 250 Q glue to the threads in the hull. 4. Screw the insert in the hull boss and torque to 25 N•m (18 lbf•ft). Ensure the flanged portion of the insert makes contact with the boss it is being screwed into. Insert Removal 1. Heat the insert using a heat gun to soften the glue securing the insert into the hull. 2. Remove any excess glue from around the head of the insert that would prevent proper insertion of the socket used to remove the insert. 510 smr2009-042