Section 09 WIRING DIAGRAM Subsection 02 (CONNECTOR INFORMATION) Connector Disassembly (& ! TYPICAL 1. Deutsch connectors 2. Press release button 1. Male connector 2. Female connector 3. Secondary lock 4. Sealing cap Engine Connector Insert a small flat screwdriver between the sup- port and the Deutsch connectors. Pry while slid- ing out connectors in the direction shown. NOTICE Do not apply dielectric grease on ter- minal inside connector. To remove terminals from connector, proceed as follows: Using a long nose pliers, pull out the lock. smr2009-045-010_a MALE CONNECTOR REMOVED FOR CLARITY PURPOSE 1. Insert screwdriver here , FEMALE CONNECTOR 1. Female lock 520 smr2009-044