Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 09 WIRING DIAGRAM Subsection 02 (CONNECTOR INFORMATION) 6. After all required terminals have been inserted, the lock must be installed. MALE CONNECTOR 1. Male lock 67: 1. Wire identification numbers NOTE: Before extraction, push wire forward to re- lieve pressure on retaining tab. 1. Insert a 4.8 mm (.189 in) wide screwdriver blade inside the front of the terminal cavity. 2. Pry back the retaining tab while gently pulling wire back until terminal is removed. ECM CONNECTOR (MOLEX) There are 2 connectors on the ECM. The engine wiring harness connector is connected on the ECM connector A and the vehicle wiring harness connector is connected to the ECM connector B.

Each ECM connector has 48 pins. smr2009-027-005 ECM CONNECTORS ECM Connector Removal To reach ECM connector, refer to ELECTRONIC FUEL INJECTION subsection. Push and hold the locking tab of the desired con- nector. FEMALE CONNECTOR 1. Retaining tabs To install: 3. For insertion of a terminal, make sure the lock is removed. 4. Insert terminal into appropriate cavity and push as far as it will go. 5. Pull back on the terminal wire to be sure the retention fingers are holding the terminal. smr2009-044 521