Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 09 WIRING DIAGRAM Subsection 02 (CONNECTOR INFORMATION) smr2009-045-013_b Rotate connector lock until it stops. smr2009-045-011_a Install connector to ECM. Rotate connector lock until it snaps locked. smr2009-045-012_a Pull out connector. smr2009-045-011_b 1. Locked here ECM Connector Inspection Before replacing an ECM, always check electrical connections. Make sure that they are very tight and they make good contact and that they are corrosion-free. Check if wiring harness shows any signs of scoring. Particularly check ECM ground connections. Ensure that contacts are good and clean. A “defective module” could possibly be repaired simply by unplugging and re-plugging the ECM.

Or if a newly replaced ECM is working, try the old one and recheck if it works. The voltage and current might be too weak to go through dirty wire terminals. Check carefully if terminals show signs of moisture, corrosion or if they look dull. Do not apply any lubricant product to the pins of the connector on the ECM. smr2009-045-013_a ECM Connector Installation Fully open connector lock. 522 smr2009-044