Section 09 WIRING DIAGRAM Subsection 02 (CONNECTOR INFORMATION) WARNING Before terminal installation, ensure all ter- minals are properly crimped on wires. After plugging connectors, ensure they are prop- erly fastened. SPS CONNECTORS (BOSCH) To remove a terminal from connector, use a spe- cial tool such as the AMP TERMINAL EXTRACTOR (P/N 726503-1) . smr2009-045-020_a 1. Pry out locking cap smr2009-045-018_a 1. Unlock terminal here smr2009-045-021_a 1. Unlock here WARNING Before terminal installation, ensure all ter- minals are properly crimped on wires. After plugging connectors, ensure they are prop- erly fastened.
smr2009-045-019_a WARNING Before terminal installation, ensure all ter- minals are properly crimped on wires. After plugging connectors, ensure they are prop- erly fastened. smr2009-045-022_a INFORMATION CENTER CONNECTORS (DELPHI) To remove a terminal from connector, first remove the locking cap. VTS, iS, MODE/SET AND UP/DOWN SWITCH CONNECTORS (DELPHI) To remove a terminal from connector, first remove the locking cap. smr2009-044 525