Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 09 WIRING DIAGRAM Subsection 02 (CONNECTOR INFORMATION) smr2009-045-023_a 1. Pry out locking cap A. 10 mm (3/8 in) NOTE: Make sure not to cut wire strands while stripping the wire. Install the appropriate terminal on the wire ac- cording to the requirement. Refer to appropriate PARTS CATALOG. smr2009-045-024_a 1. Unlock here INSTALLATION OF TERMINAL Follow the instructions provided with the CRIMP- ING TOOL (HEAVY GAUGE WIRE) (P/N 529 035 730) to select the proper position of the tool. 529035730 NOTE: Different wires require different crimping pliers settings, so make sure to follow the instruc- tion supplied with the tool.

smr2009-045-028_a WARNING Before terminal installation, ensure all ter- minals are properly crimped on wires. After plugging connectors, ensure they are prop- erly fastened. BATTERY CABLE TERMINAL Crimping Carefully strip the wire approximately to 10 mm (3/8 in) in length, using a wire stripping tool or sharp blade/knife. 526 smr2009-044