Section 09 WIRING DIAGRAM Subsection 02 (CONNECTOR INFORMATION) Install the protective heat shrink rubber tube on the terminal. Heat the heat shrink rubber tube us- ing the heat gun so that it grasps the wire and the terminal. NOTICE Make sure that the protective heat shrink rubber tube has been properly installed and no part of wire is exposed. # POSITIONING THE CRIMPING PLIERS Step 1: Press Step 2: Rotate After positioning the crimping pliers, crimp the ter- minal already installed on wire. CRIMPING OF WIRE PROPERLY CRIMPED WIRE To verify, if the wire is properly crimped, apply some pulling force on wire and the terminal at the same time from both directions.
NOTICE Never weld the wire to the terminal. Welding can change the property of the wire and it can become brittle and break. smr2009-044 527