Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 03 (INTAKE MANIFOLD) GENERAL Cut all locking ties securing the harness to the in- take manifold. During assembly/installation, use torque values and service products as in the exploded view. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be replaced with new ones. Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards.

smr2009-018-002_a 1. Cut these locking ties to release harness PROCEDURES INTAKE MANIFOLD Intake Manifold Removal Remove the moving deck and the deck extension. Refer to BODY subsection. Remove the air intake silencer. Refer to AIR IN- TAKE SYSTEM subsection. Disconnect the intake hose at intake manifold. smr2009-018-003_a 1. Cut these locking ties to release harness smr2009-018-020_a 1. Intake hose Move the coolant expansion tank aside to make room. Remove the oil dipstick. Release the fuel pressure. Disconnect fuel hose connector at fuel rail. Refer to ELECTRONIC FUEL INJECTION subsection. smr2009-018-004_a 1.

Cut these locking ties to release harness Unplug the ignition coil and fuel injector connec- tors. 32 smr2009-018