Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 03 (INTAKE MANIFOLD) smr2009-018-013_a INTAKE MANIFOLD 1. Gaskets Ensure to properly route and secure wiring har- ness with locking ties. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on the ECM retaining screws and torque them to 9 N•m (80 lbf• in ). First, position intake manifold on front mounting bracket then push manifold toward engine to then proceed with rear mounting bracket. When installing the intake manifold, lift up the oil dipstick tube a little bit to fit in the slot of the man- ifold. FLAME ARRESTER Flame Arrester Location The flame arrester is integrated in the intake man- ifold. 1. Oil dipstick tube smr2009-018-014_a 1.

Flame arrester Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on the intake manifold screws. Torque them to 9 N•m (80 lbf• in ) following the tightening sequence as shown in next illustration. Flame Arrester Inspection The flame arrester in the intake manifold is main- tenance free. Flame Arrester Replacement NOTE: The flame arrester can not be removed from the intake manifold. Replace intake manifold if necessary. Refer to IN- TAKE MANIFOLD in this subsection. smr2009-018 35