Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 04 (SUPERCHARGER) GENERAL During assembly/installation, use the torque val- ues and service products as in the exploded view. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, cotter pins, etc.) must be replaced with new ones. smr2009-020-011_a MANY PARTS REMOVED FOR CLARITY PURPOSE 1. Support screws Remove the air inlet hose from supercharger.

Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards. INSPECTION SUPERCHARGER INLET CLEANLINESS NOTE: A lower than usual maximum RPM at full throttle might be caused by a dirty supercharger inlet. Remove the deck extension. Refer to BODY sub- section for proper procedure. Remove the air intake silencer. Refer to AIR IN- TAKE SYSTEM subsection. Remove the air intake silencer support. smr2009-020-012_a 1. Air inlet hose 2. Hose clamp Visually inspect supercharger inlet side for oil, salt or any other deposits. smr2009-020-010_a 1. Air intake silencer support smr2006-012-010_a 1. Dirt here If dirt is found, proceed as follows. smr2009-020 39