Section 02 ENGINE Subsection 04 (SUPERCHARGER) Remove supercharger and perform the clutch slip- ping moment test. Inspect bearings and friction clutch. Replace bearings and clutch components as necessary. Separate supercharger housing. NOTE: Since supercharger is disassembled, it is recommended to completely inspect it. Clean internal housing and turbine using a brush and cleaning solvent to get rid of oil deposits. Blow dry with compressed air. Remove the air inlet hose from supercharger. NOTICE Do not let turbine spin when using compressed air. smr2009-020-012_a 1. Air inlet hose 2. Hose clamp Complete usual assembly procedures as de- scribed in this subsection.
Remove cylinder head cover, refer to CYLINDER HEAD subsection. Remove spark plugs. Turn engine by rotating the supercharger nut counterclockwise until the position lines on oil separator cover are lined up as shown in the following illustration. SUPERCHARGER CLUTCH SLIPPING MOMENT (ON ENGINE) Remove the deck extension. Refer to BODY sub- section for proper procedure. Remove the air intake silencer. Refer to AIR IN- TAKE SYSTEM subsection. Remove the air intake silencer support. smr2009-025-006_a 1. Position lines smr2009-020-010_a 1.
Air intake silencer support Lock camshaft with the CAMSHAFT LOCKING TOOL (P/N 529 035 839) to prevent camshaft rotation while checking slipping moment of su- percharger. 529035839 smr2009-020-011_a MANY PARTS REMOVED FOR CLARITY PURPOSE 1. Support screws 40 smr2009-020