Section 02 ENGINE Subsection 04 (SUPERCHARGER) smr2009-020-006_a 1. Cap nut (left-handed thread) 4. Remove washer, turbine, O-ring and step collar from supercharger shaft. 1. Nut 2. Retaining key NOTE: There are 40 loose needle bearings under the gear. Do not reuse. 6. Remove L-ring, spring washers, lock washer, drive gear and needle pins by turning the super- charger upside down. smr2009-020-007_a 1. Washer 2. Turbine 3. O-ring 4. Step collar 5. Loosen nut on supercharger shaft engine side while holding shaft with the SUPERCHARGER RETAINING KEY (P/N 529 036 027) . smr2006-012-008_a 1. Nut 2. L-ring 3. Spring washers (5x) 4. Lock washer 5. Titanium shims 6. Drive gear 7. Needle bearings 7.
Carefully push out supercharger shaft towards engine side by using a press. smr2009-020 45