Section 02 ENGINE Subsection 04 (SUPERCHARGER) Supercharger Assembly NOTICE Every time when supercharger shaft has been removed, both ball bearings have to be replaced. A. Driven plate journal depth B. Drive gear thickness C. Lock washer thickness NOTICE Both ball bearings have to be in- stalled with cages facing turbine side. 1. Apply enough engine oil on NEW ball bearing. 2. Install ball bearing on supercharger shaft by us- ing the SUPPORT PLATE (P/N 529 035 947) to hold bearing. NOTICE Ensure to position ball bearing against protrusion of support plate for the in- stallation.
This way, the installation pressure will be applied to the inner race and will not be transmitted to the bearing balls which would otherwise shorten the bearing life. 529035947 Spring Washer Put spring washer package together as it is as- sembled on the supercharger shaft. Measure the height of the unloaded spring washer package. NOTICE To install ball bearings and super- charger shaft always use a press, never use any beating force like a hammer. A.
Spring washer package height smr2009-020 47 SPRING WASHER PACKAGE HEIGHT NEW 10.7 mm to 10.9 mm (.4213 in to .4291 in) SERVICE LIMIT 10.2 mm (.4016 in) DRIVEN PLATE JOURNAL DEPTH NEW 14.460 mm to 14.500 mm (.5693 in to .5709 in) SERVICE LIMIT 14.600 mm (.5748 in) DRIVE GEAR THICKNESS NEW 11.000 mm to 11.050 mm (.4331 in to .435 in) SERVICE LIMIT 10.900 mm (.4291 in) LOCK WASHER THICKNESS NEW 4.050 mm to 4.150 mm (.1594 in to .1634 in) SERVICE LIMIT 3.950 mm (.1555 in)