Section 02 ENGINE Subsection 04 (SUPERCHARGER) Supercharger Installation 1. Grease sealing surface between supercharger and PTO housing with SUPER LUBE GREASE (P/N 293 550 030) . NOTE: Ensure O-rings are installed. 529035949 27. Tighten the cap nut to 29 N•m (21 lbf•ft). 28. Apply LOCTITE 5910 (P/N 293 800 081) on super- charger housing sealing surface. 1. Super Lube grease 2. Install supercharger on PTO housing. 3. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on the retaining screws. 4. Torque retaining screws to 9 N•m (80 lbf• in ). 4.1 To tighten and torque the upper retaining screw, use the TORX ADAPTOR (P/N 529 035 938) . 1. Apply Loctite 5910 on sealing surface 29.
Assemble supercharger housing halves. Ap- ply LOCTITE 243 (BLUE) (P/N 293 800 060) on re- taining screws and torque to 9 N•m (80 lbf• in ) according to the following sequence. 529035938 5. Ensure to install the tool perpendicularly (90°) to torque wrench to apply the proper torque to the screw. SUPERCHARGER TIGHTENING SEQUENCE 30. Verify the clutch slipping moment. Refer to SUPERCHARGER CLUTCH SLIPPING MO- MENT (BENCH TEST) in this subsection. 1. Tool perpendicular (90°) to torque wrench A. 90° smr2009-020 51