Section 02 ENGINE Subsection 04 (SUPERCHARGER) 13. Install step collar, O-ring, turbine and washer on supercharger shaft. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on cap nut and tem- porary finger tight cap nut. NOTE: The cap nut on the supercharger shaft has a left-handed thread. The Loctite has to be applied in a small dose into the nut. 20. Install the second titanium shim. 21. Install the lock washer. 22. Apply engine oil to the spring washers. 23. Position the spring washers as per illustration. NOTICE When installing the spring washers, take care of the exact installation direction of the washers. smr2006-012-009_a 1. Spring washers smr2009-020-007_b 1. Step collar 2. O-ring 3.
Turbine 4. Washer 5. Cap nut 24. Install the L-ring on the compressor shaft. 25. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on the hexagonal nut threads. Torque to 29 N•m (21 lbf•ft). 14. Complete installation of supercharger shaft, engine side as follows: NOTICE It is of the utmost importance that all parts be absolutely clean. The compressor shaft spins at up to 45 000 RPM and any debris could cause a failure. 15. Install the first titanium shim. NOTE: The titanium shims have the same inner diameter. NOTICE Manipulate titanium shims with care, those parts are sensitive. smr2006-012-008_a 1. Nut 2. L-ring 3. Spring washers 4. Lock washer 5. Titanium shims 6. Drive gear 7.
Needle bearings 16. IMPORTANT: Apply ISOFLEX GREASE TOPAS NB 52 (P/N 293 550 021) to the inner diameter of the gear thrust surface on the shaft, titanium shims, needle bearings, shaft surface and lock washer. NOTE: The L-ring will preload the spring washers. 26. Hold the lock washer of the supercharger shaft (engine side) using the SUPERCHARGER RETAINING KEY (P/N 529 036 027) . NOTICE No other grease can be used, other- wise damage to bearings will occur. 17. Install the 40 needle bearings on the compres- sor shaft. NOTE: The 40 needle bearings comes in a wax strip with an adhesive backing. 18. Remove the adhesive backing. 19. Install the drive gear over the needle bearings. 50 smr2009-020