Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 06 (EXHAUST SYSTEM) GENERAL During assembly/installation, use torque values and service products as in the exploded view. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, cotter pins, etc.) must be replaced with new ones. Water exits exhaust pipe through holes at the end of the water jacket and mixes with exhaust gas in the muffler.

smr2008-013-008_a Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards. SYSTEM DESCRIPTION The exhaust system is protected by its own cool- ing system, an opened loop type. The water supply is provided by a pressurized area in the jet pump between the impeller and venturi. Water is directed first through the exhaust mani- fold fitting located at front of manifold. Water enters the manifold end and is directed to water jackets of exhaust manifold. smr2008-013-009_a 1. Water packet holes Water is evacuated from muffler then through the exhaust outlet in transom area. Exhaust System Technical Specifications smr2009-021-002_a 1.

Exhaust manifold water inlet 2. Exhaust manifold 3. Exhaust manifold water outlet (to pump support) 4. Exhaust manifold water outlet (to exhaust pipe and muffler) Water exits exhaust manifold through 2 hoses at rear manifold. MAINTENANCE EXHAUST SYSTEM FLUSHING Flushing the exhaust system with fresh water is essential to neutralize corroding effects of salt or other chemical products present in water. It will smr2009-021 61 TYPE Total Loss Cooling System (TLCS) WATER FLOW Flow from jet pump (no water pump) TEMPERATURE CONTROL Calibrated outlet fittings (no thermostat) SYSTEM BLEEDING Self-bleed type SYSTEM DRAINING Self-drain type