Section 02 ENGINE Subsection 06 (EXHAUST SYSTEM) help to clean up sand, salt, shells or other particles in water jackets (exhaust system, intercooler and hoses. Exhaust system flushing should be performed when the watercraft is not expected to be used further the same day or when the watercraft is stored for any extended time. NOTICE Failure to flush the system, when necessary, will severely damage intercooler and exhaust system. Make sure engine oper- ates during entire procedure. 1. Quick connect adapter 2. Flushing connector adapter To flush the exhaust system, start the engine then immediately open the water tap. WARNING Perform these operations in a well ventilated area.
Certain components in the engine compartment may be very hot. Direct con- tact may result in skin burn. Do not touch any electrical part or jet pump area when engine is running. NOTICE Always start the engine before opening the water tap. Open water tap im- mediately after engine is started to prevent overheating. Never run engine without sup- plying water to the exhaust system when watercraft is out of water. Run the engine about 20 seconds at a fast idle between 4000 - 5000 RPM. WARNING When operating the engine while the water- craft is out of the water, the heat exchanger in the ride plate may become very hot. Avoid any contact with ride plate as burns may oc- cur.
NOTICE Never run engine longer than 2 min- utes. Drive line seal has no cooling when wa- tercraft is out of water. Ensure water flows out of jet pump while flushing. Close the water tap, then stop the engine. Connect a garden hose to connector located at the rear of watercraft. Do not open water tap yet. NOTICE Always close the water tap before stopping the engine. Disconnect the garden hose. NOTICE Remove flushing connector adapter after operation (if used). PROCEDURES MUFFLER Muffler Removal WARNING Certain components in the engine compart- ment may be very hot. Direct contact may result in skin burn. Let exhaust system cool down prior to removing parts. smr2009-021-004_a 1.
Water inlet connector NOTE: The optional FLUSHING CONNECTOR ADAPTER (P/N 295 500 473) can be used with a quick connect adapter to ease garden hose instal- lation. 1. Remove the air intake silencer. Refer to AIR IN- TAKE SYSTEM subsection. 2. Cut locking tie securing water outlet hose (ex- haust system) and blow-by hose. 3. Disconnect the water outlet hose from the ex- haust manifold. 62 smr2009-021