Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 06 (EXHAUST SYSTEM) 3. Disconnect the exhaust manifold water outlet hose. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of screws. To help holding the manifold while installing screws, first insert the exhaust manifold into the exhaust pipe then, install the upper front screw. Continue with the remaining screws. Torque screws to 9 N•m (80 lbf• in ) as per follow- ing illustrated sequence. Repeat the procedure, torquing screws again to 9 N•m (80 lbf• in ). smr2009-016-023_a 1. Water outlet hose 2. Exhaust manifold 4. Disconnect exhaust manifold water inlet hose from exhaust manifold.

After installation, ensure there is no water or ex- haust gas leak when the engine is running. Test run the engine while supplying water to the flush- ing connector. smr2009-016-024_a 1. Exhaust manifold water inlet hose 5. Unscrew the exhaust manifold beginning with the bottom screws. This will help holding the manifold while you remove the screws. 6. Move the manifold rearwards to remove it from vehicle. NOTICE Never run engine without supplying water to the exhaust system when watercraft is out of water. RESONATOR Exhaust Manifold Inspection Inspect exhaust manifold condition paying atten- tion for cracks or other damage. Check contact surfaces and hose. Replace any defective part.

Inspect plane surfaces for warpage. Small defor- mation can be corrected by grinding surface with a fine sand paper. Install sand paper on a surface plate and rub part against oiled sand paper. Clean all metal components in a solvent. Resonator Removal Remove engine from vehicle. Refer to ENGINE REMOVAL AND INSTALLATION subsection. Remove battery and battery holder. Refer to CHARGING SYSTEM subsection. Loosen clamp securing rear exhaust hose to res- onator. Remove the front exhaust hose from resonator. Remove resonator from vehicle. Exhaust Manifold Installation Installation is essentially the reverse of removal procedures. However, pay particular attention to the following. NOTE:

There is no gasket between cylinder block and exhaust manifold. Resonator Inspection Inspect parts condition paying attention for defor- mation, cracks or other damage. Check hoses. Replace any defective part. smr2009-021 67