Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 06 (EXHAUST SYSTEM) smr2008-013-035_a 1. Bulge 2. Middle of the opening smr2008-013-037_a 1. Middle of rubber adapter strip 2. Center of the muffler bulge opening Install the rubber adapter on exhaust pipe. Ensure rubber adapter is properly seats against exhaust pipe shoulder. Using a caliper, measure the distance between the exhaust pipe shoulder and the outside of the muffler bulge. Position the muffler to 95 mm ± 2 mm (3.74 in ± .079 in). Check the distance in several places. smr2008-013-038_a 1. Exhaust pipe shoulder 2. Rubber adapter Center the rubber adapter strip of the rubber adapter between both exhaust pipe marks.

Tighten retaining clamp to 8 N•m (71 lbf• in ). smr2008-013-039_a 1. Rubber adapter end 2. Outside of the muffler bulge A. 95 ± 2 mm (3.74 ± .0787 in) Tighten retaining clamp to 8 N•m (71 lbf• in ). Install muffler in vehicle. Refer to MUFFLER IN- STALLATION in this subsection for complete pro- cedure. EXHAUST MANIFOLD smr2008-013-036_a 1. Rubber adapter strip 2. Retaining clamp 3. Exhaust pipe marks Exhaust Manifold Removal 1. Remove the moving deck and the deck exten- sion. Refer to BODY subsection. 2. Move muffler rearwards to make room. Refer to MUFFLER REMOVAL in this subsection to know how separate muffler from exhaust man- ifold. Slide the other clamp on the rubber adapter.

Insert the exhaust pipe into the muffler. Align the center of the rubber adapter strip with the mark previously traced on muffler. 66 smr2009-021