Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 06 (EXHAUST SYSTEM) Move the coolant expansion tank aside and cut locking tie retaining the starter cable (RED) to ex- haust hose. Remove exhaust hose from resonator. Cut locking tie retaining bailer hose elbow fittings to exhaust hose. Remove front exhaust hose from vehicle. When reinstalling exhaust hose, make sure to at- tach elbow fittings at the highest position that you can on the exhaust hose. Tighten retaining clamps to 4 N•m (35 lbf• in ). Install all other removed parts. After installation, ensure there is no water or ex- haust gas leak when the engine is running. Test run the engine while supplying water to the ex- haust system. smr2008-013-033_a 1.

Water inlet hose 2. Exhaust pipe Loosen rubber adapter clamps. NOTICE Never run engine without supplying water to the exhaust system when watercraft is out of water. Rear Exhaust Hose Replacement Remove battery and battery holder. Refer to CHARGING SYSTEM subsection. Loosen clamps securing rear exhaust hose to res- onator and iBR support plate. Remove the rear exhaust hose from vehicle. When reinstalling rear exhaust hose, tighten clamps to 4 N•m (35 lbf• in ). Reinstall all other removed parts. After installation, ensure there is no water or ex- haust gas leak when the engine is running. Test run the engine while supplying water to the ex- haust system. smr2008-013-034_a 1. Muffler 2.

Rubber adapter 3. Clamps 4. Exhaust pipe Remove exhaust pipe and the rubber adapter. Exhaust Pipe Inspection Inspect exhaust pipe for: Cracks Flange damages Other damages. Replace exhaust pipe as required. Check if the rubber adapter is: Brittle Hard Otherwise damaged. Replace rubber adapter if necessary. NOTICE Never run engine without supplying water to the exhaust system when watercraft is out of water. EXHAUST PIPE Exhaust Pipe Removal Remove MUFFLER, see procedure in this subsec- tion. Disconnect water inlet hose from exhaust pipe fit- ting. Exhaust Pipe Installation Trace a mark to locate the middle of the muffler bulge opening. smr2009-021 65