Section 02 ENGINE Subsection 06 (EXHAUST SYSTEM) smr2008-013-025_a 1. Exhaust manifold mark 2. Exhaust pipe mark smr2008-013-026_a Step 1: Lift adjuster tab Step 2: Move adjuster outward Tighten exhaust clamp to 11 N•m (97 lbf• in ). NOTICE Do not use pneumatic or electric tools as seizure may occur. Using the rear opening, slide the muffler in hull. Align the exhaust pipe flange to the exhaust mani- fold. Rotate and move muffler so that the exhaust pipe flange makes perfect contact with exhaust manifold. Slide both adjuster blocks against muffler to sup- port it in position. NOTE: Ensure muffler is in contact with both ad- juster blocks. Readjust as required.
Install exhaust clamp with the nut upward. Tighten clamp loosely. Using a 50 mm (2 in) spacer (in this case a bolt), position the exhaust pipe. Install the muffler strap. NOTICE Ensure not to rotate muffler during strap installation. The use of a soapy water so- lution on inner side of muffler strap is recom- mended. Install all other removed parts. After installation, ensure there is no water or ex- haust gas leak when engine is running. Test run the engine while supplying water to the exhaust system. NOTICE Never run engine without supplying water to the exhaust system when watercraft is out of water. EXHAUST HOSES Front Exhaust Hose Replacement Remove the LH rear storage basket.
Remove exhaust hose from muffler outlet. smr2008-013-027_a 1. Engine lifting ring 2. Spacer 3. Exhaust pipe fitting Confirm that the exhaust pipe mark is aligned with the mark on the exhaust manifold. smr2009-021-010_a 1. Retaining clamp 2. Exhaust hose Remove the deck extension. Refer to BODY sub- section. 64 smr2009-021