Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) GENERAL ENGINE WILL NOT START (ENGINE DOES NOT TURN OVER) NOTE: It is good practice to check for fault codes using the B.U.D.S. software as a first trou- bleshooting step. Refer to the MONITORING SYSTEM AND FAULT CODES subsection. Always carry out electrical tests on components before removing or installing them. During assembly, use torque values and service products as in the exploded view. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. 1. Obstructed starter drive gear assembly - Check and repair the starter drive.

ENGINE WILL NOT START (ENGINE TURNS OVER) 1. Defective or loose CPS - Check operation of CPS and replace if necessary. 2. Defective trigger wheel - Check trigger wheel teeth if bent or damaged. 3. Defective starter drive gear assembly - Check and repair the starter drive. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be installed or replaced with new ones. ENGINE CONTINUALLY BACKFIRES 1. Defective trigger wheel - Check trigger wheel teeth if bent or damaged. 2. Defective or loose CPS - Check operation of CPS and replace if necessary.

Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards. Always disconnect the negative wire from the bat- tery before working on the engine. STARTER TURNS, BUT STARTER DRIVE DOES NOT MESH WITH RING GEAR 1. Worn starter drive gear - Replace starter drive assembly. 2. Defective starter drive - Replace starter drive assembly. WARNING Always disconnect the BLACK (-) cable first and reconnect last. 3. Poor movement of the drive on splines - Clean and correct. 4. Worn drive bushing - Replace starter drive assembly.

WARNING Before carrying out any inspection or main- tenance procedure on the vehicle, wait until the engine and exhaust have cooled down to avoid potential burns. 5. Worn ring gear - Replace ring gear. TROUBLESHOOTING OIL CONTAMINATION (WHITE APPEARANCE) 1. Water ingestion through drive shaft and floating ring - Check if water is leaking between drive shaft and floating ring. Repair or replace defective parts. - Change engine oil and filter. The following is provided to help in diagnosing the probable source of troubles. It is a guideline and should not be assumed to list all possible prob- lems. Always check for fault codes. If a fault code is de- tected, service the fault code first.

Refer to MON- ITORING SYSTEM AND FAULT CODES subsec- tion. PROCEDURES PTO HOUSING PTO Housing Removal 1. Disconnect the battery. smr2009-022 71