General Information 0A-31 Recommended Liquid Gasket Recommended Liquid Gasket Make sure to use a liquid gasket with the above product name or equivalent. Do not use LOCTITE 515, 518 or FMD 127, as they are anaerobic, and do not provide sufficient effect when there is a gap larger than 0.25 mm (0.010 in) between the contact surfaces of metals. Use an appropriate amount of liquid gasket. Follow the handling precautions for the product. Application method 1. Wipe any water or oil from the contact surface. Make sure the contact surface is dry. 2. Apply liquid gasket of the specified bead width to one side of the contact surface. Make sure there are no cuts in the beads. 1.
Completely remove lubricant and moisture from the connecting surfaces. The surfaces must be perfectly dry. 2. Apply specified bead width of liquid gasket to one of the connecting surfaces. There must be no gaps in the bead.
mm (in) SCREW HOLE JUDGE MENT DEPRESSION 1 3 (0.040.12) OK 13 (0.040.12) More than 2 (0.08) OK Depression Apply liquid gasket to the bolt hole interior Specified bead width NG Example Anaerobic Type :2-3 mm (0.08-0.12 in) Others :2-6 mm (0.08-0.24 in) MFW70AMF000101 Type Product name Manufacturer name Area used (reference) Silicon type (Room temperature vulcanization process) ThreeBond 1207B ThreeBond 1207C ThreeBond 1215 ThreeBond 1216 ThreeBond 1281 ThreeBond ThreeBond ThreeBond ThreeBond ThreeBond Engine oil seal retainer Engine oil pan Timing gear case Cylinder head cover Fuel pump Water pump Rear axle Etc.
Water Base ThreeBond 1141E ThreeBond Solvent ThreeBond 1102 ThreeBond 1104 ThreeBond 1194 ThreeBond ThreeBond ThreeBond Anaerobic LOCTITE 515 LOCTITE 518 LOCTITE 17430 FMD127 LOCTITE LOCTITE LOCTITE LOCTITE Engine oil seal retainer Water pump Transaxle Etc.