Encoder diagnostics | Diagnosis for encoders with TTL/HTL/HTLs/ interface 8 Defining the count values The Set the count value: parameter contains the starting value from which the product starts counting. The following instruction describes the entry of the count value: Tap More The More menu is opened. Tap Counter The Display options for count value screen is opened. Tap the Off option of the Reset the count value with the reference mark: parameter Tap the On option of the Set the count value: parameter Count value [steps] is displayed. Tap Count value [steps] The product's on-screen keyboard is opened. Enter the desired starting value Tap OK Tap Back The changed settings are applied.
The Display options for count value screen is closed. Analysis information screen Figure 50: Analysis information screen The Analysis information screen shows messages on the signal analysis. The messages depend on the encoder functions. You can reset the messages. 112 HEIDENHAIN | PWT 100, PWT 101 | Operating Instructions | 07/2024