heidenhain PWT 100, PWT 101 — Display options for count value screen

8 Encoder diagnostics | Diagnosis for encoders with TTL/HTL/HTLs/ interface Display options for count value screen Figure 49: Display options for count value screen The Display options for count value screen enables you to define display options for the count value. The setting options vary depending on the encoder functions. The product adapts the displayed setting options correspondingly. Encoders with EnDat interface and additional incremental signals allow manual setting of the count value. Resetting the count value The count value counts the signal periods of the incremental signals of the connected encoder. The count value is always an incremental value.

The Reset the count value with the reference mark: parameter provides the following options: Selection Description Off The count value counts the signal periods without any other starting conditions. If this option is selected, you can set the Set the count value: parameter to On and enter a starting value in the Count value [steps] field. After tapping Back, the count value is set to the starting value entered and the product starts counting. Once The count value is set to "0" and counting starts with the detection of the reference mark. When the count value is detected, the parameter is set to Off again.

With each The count value is set to "0" and counting starts with the detection of the reference mark. When the next reference mark is detected, the count value display freezes for approx. 0.5 s. This enables you to check the number of signal periods between reference marks for distance-coded encoders, for example. c-Coded The count value is set to "0" and is then changed to the correspond- ing count value after the coding of the reference marks has been detected. When the count value is detected, the parameter is set to Off again. HEIDENHAIN | PWT 100, PWT 101 | Operating Instructions | 07/2024 111