Start and stop the vehicle 109 13. Before driving the vehicle, the seat belts on both sides must be reset, and the seat belts can be reset by operating in the reverse sequence as in Step 11. This is the end of the windshield overturning operation. 2 Loosen the expansion screws (2 on each side, 4 in total) as shown in the figure and remove the B-pillar trim panel (the picture here takes the right side of the vehicle as an example). 12. Remove the fastening bolts connecting the B-pillar to the left and right anti-roll bars. There are 6 fastening bolts on each side for a total of 12.
(the picture here takes the right side of the vehicle as an example) Then remove the anti- roll bars on both sides and place them in a safe place. Attention The expansion part of the expansion screw and the fastener for fixing the B-pillar trim panel are disposable parts, which need to be replaced after disassembly. These bolts have a torque requirement of 24±2N·m when installed. Attention